Since 2002 , focus on manufacturing and supplying various kinds of bonded ferrite magnets


Magnets should pass when we do the injection, we should pay attention to what issues?

by:Maghard      2020-09-02
Magnets should pass when we do the injection, we should pay attention to what issues? As we all know, the process of injection molding is a very high temperature, the temperature higher than one hundred degrees of above. So all we have to through the plastic injection molding magnets, magnet manufacturer we will how to avoid the high temperature lead to the condition of the magnet demagnetization? To tell the magnets below our manufacturer. Magnet heat resistance is generally 80 degrees to 100 degrees of this range, there are very few customers will require increased temperature to 150 degrees, the 150 - degree for our professional magnet manufacturer, this belongs to the high performance materials magnets, the production cost of materials will is much better than the ordinary type of material properties. Our magnet manufacturer experience summed up, the general customers to use the high temperature of the magnet, because the magnet after high temperature or using in high temperature environment. When we understand customer use of magnet, can give customers some corresponding solutions. If the customer magnets is to go through to ask when we do the injection, we do not recommend customers to use high temperature materials, considering the cost at the same time, also for the customer consider ordinary material can meet the demand of customers in the use after injection, in many ways after considering some practical solutions to clients. So we magnet after injection, we are professional manufacturer of magnet, generally do not recommend customers to use high-performance materials. But use normal performance of material, through the general performance of the material after injection into the plastic first, then to the magnetization of the magnet, so can not only ensure the magnet magnetic is not affected, also save the cost for the customer.
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...